The Antaris wind turbine is specially adapted to sites inland. It is specially designed for network connection, charging batteries (24VDC / 48 VDC etc.) and powering heating systems. Because of its robust design, the Antaris wind turbine is also suitable for storm-prone locations.
The rotor blades are laminated by hand and benefit from a computer-designed aerodynamic profile, they are also balanced statically and dynamically. Each blade has an identification number and comes with its appropriate documentation. The highest importance has been to ensure the speed and simplicity of installation of this wind turbine.
Thanks to its robust and careful design, the Antaris wind turbine has excellent efficiency and is offered at a highly attractive price. It starts very quickly (starting already at a wind speed of 2.2 m/s) and operates silently (43 dB). This wind turbine can therefore be installed in residential areas.
The connection to the network requires the use of two inverters programmed specifically to operate with Antaris wind turbines as well as according to local wind conditions. In less windy areas, it is possible to connect the wind turbine to the grid via a single inverter. The inverters come with a declaration of compliance. The ENS (Electronic grid guard system) is integrated into the inverter.
Technical features
Generator
Permanent magnet rotor without brooms and gears. Doesn't require maintenance!
NdFeBo permanent magnets very powerful for great efficiency, resists up to 150oC
Phase
Separate lifter
Rotation in both directions
Tension 0-1000 VDC
Starts production at about 100 t/mn
Power: 6000 watts at 380 t/mn and 400V
Linear power curve
Weight: 31kg
Carter aluminum, cooling of the surface and the fastening base
Protection IP56
Rotor
Connection hubs with aluminum strap and overpressure plate
Stainless steel fitting screws and counter-nuts
3 Carbon rotor blades
Computer-designed aerodynamic profile
Noise reduction on the end of the blades
4m in diameter
Blade weight: 3.3 kg
Dynamically balanced
Anti-clockwise rotational sense
Rotation speed up to 300 t/min
GRP spinner cap
The colour of the rotor of your choice
Chassis
Weather-resistant HDPE Girouette
Support element: stainless steel square tube
All threaded fittings are made of stainless steel and equipped with nuts
Steel support for the generator, configured for plug-in in the azimut bearing frame, fully galvanized
Protected by a patented rotor-blade positioning system
Mast adapter with bridle connector (114.3 mm tube)
Storm protection
Switching the pale rotor to the "helicopter" position
Electronic control of turbines
Control cabinet
Control system with voltage monitor
Electronic control of turbines with regulator
Connector protections against polarity inversions
Controlling the phases of the alternator during the turbine mode
Emergency shutdown switch
Key switch re-initializer (removable)
2x 3 kW braking resistance
Inverter Smart wind 5kW
Three-phase power converter for small wind turbines
MODERN - FLEXIBLE - POWERFUL
Max. 20 kW wind turbine charge (SW-10) Three-phase network coupling with 10 kW (SW-10) Flexible and intelligent management of clean power, heating, battery and discharge charges through 4 separate CC energy outlets Energy meter for power and heating Reactive power control Battery buffer interface - optional
Compact
Direct connection of the particle generator without additional equipment Wide range of input voltage for particle generators Compact case design with separate aperture connection area Passive convection cooling on a wide range of performance Integrated network/system protection (NA protection according to VDE AR-N 4105)
PROFITABLE - SURE
Built-in control features for a wind turbine Intelligent and finely tuned characteristic curve for optimal wind use Characteristic curve freely selectable depending on voltage or speed Many monitoring functions, such as wind speed or speed Switch to stop the KWEA with other safety features
Communicative
Built-in graphics display Built-in web server Smart!wind Explorer PC's convenient use and setting interface
APPLICATION AREAS
Small wind turbines Small hydroelectric plants Mini-cogeneration